INNOVATORS CLUB ST. FRANCIS HIGH // CAD · HARDWARE · SOFTWARE
← Back to Portfolio
> project log

SFHS Athletics Logo Keychain

Timeline: September Status: Final design complete, printing for the fundraiser
Finished keychain: gold Spartan helmet on a black and brown shield with a sword in a sheath

What this project is

A keychain built around the Saint Francis athletics logo: a shield carrying the Spartan helmet, with a working sword that slides into a sheath built into the shield itself. It was modeled from scratch in CAD and printed as four separate pieces, so every color on it is a real printed part rather than paint.

It was much harder to make than expected. The first prototype failed the moment it was shown to Mr. Bourdon: the sword slid straight out of its sheath. Getting the parts to seat together and the sword to hold took redesigning the mechanism and adjusting dimensions by hundredths of an inch, over more than 25 failed prints and two full spools of filament.

It is sold to fund Innovators Club projects. The process was the same loop the rest of the club runs on: imagine it, build it, fail, improve it, and try again.

CAD 3D Printing

How it came together

01
Modeled From Scratch

Shield, helmet, and sword drawn in CAD as separate parts so each color prints on its own.

02
The Sword Fell Out

First prototype was shown to Mr. Bourdon and the sword slid straight out of the sheath.

03
Tolerance Work

Mechanism redesigned and dimensions adjusted by hundredths of an inch until the parts held.

04
Final Version

Over 25 failed prints and two spools of filament later, the design is finished and printing.

What's actually in it

PARTSFour printed pieces — shield frame, backing, helmet, removable sword
DESIGNModeled from scratch in CAD
MECHANISMSword slides into a sheath built into the shield
ITERATIONS25+ failed prints, two full spools of filament
PURPOSESold to fund Innovators Club projects

Build photos, slide by slide